Hi All,
I have confusion for Retry mechanism of SAP MEINT Queue Monitor. I know that for any failure message I can retry through the “Retry” event from Queue Monitor. But is it possible that system will retry automatically. Suppose suddenly SAP ECC went down and I want that MEINT will try automatically to push the message to SAP ECC based on the number of Retry value set.
I have tested one scenario but did not get positive result. I cut the SAP ECC connection (through JCO settings) in MEINT and sent some confirmation messages from SAP ME. I found those messages in MEINT Queue Monitor and after certain time interval all those messages were failed because of unavailability of JCO. Then I changed the JCO settings as it was previous. But MEINT did not retry those messages. Manually I have selected those messages and clicked Retry event and all messages became success. Is there any standard way available that scheduler will retry automatically (without putting those messages in Failed status through one try only) if SAP ECC connection is not available? Currently I am not thinking for any customization in standard BLS if any standard way is available for the same.
I am using SAP MEINT 6.1.2.
Thanks in Advance
Chandan